Restart DM780 and you should be good to go. If you get this wrong the radio will operate in QSK RTTY mode, it is pretty strange and an clue that you need to change this setting. I have SDRuno up and running and tracking the FT-3000. Omni-Rig is set for RIG1 COM-5, which is the Enhanced COM port for the FT-3000.
I set the CAT control in SDRuno to COM-10 and connected. Next just while we are in the neighbor lets setup CW keying, since the radio is setup for CW DTR keying, we need the same setting here.įinally lets setup FSK keying, it is pretty simple if DTR is being used for CW keying FSK keying will use the other pin which is RTS. I launched Ham Radio Deluxe and set up a new Port, using Yaesu, FT-3000, COM-11, RTS-checked, Baud 38400. This is critical, if you don’t do this a conflict will occur when keying is attempted. PTTįirst change is to setup PTT to use HRD for keying via CAT commands. While CW is via DTR and FSK keying is via RTS both on the standard port. All of the serial CAT commands flow between HRD and the radio on the enhanced port. In my setup the standard port is on port 12 and the enhanced port in on 13. Ok at this point the radio is expecting FSK signaling via the first serial USB port ie the lowest number.
0 kommentar(er)
